Remove tank from wrapper. Simply unscrew drip tip. Do not lose O-Ring as it may cause leaking problems.
DO NOT pour liquid down center hole, and remember to shake before you vape! (Shake bottle so nicotine is not settled.)
Hold tank/clearomizer at 45° angle, take eye dropper or e-juice bottle & pour liquid down the side of tank to fill line, about 1.6ML.
Screw on drip tip. Let the wick soak for a few minutes, it may take a few vapes\draws to get full flavor as your wick needs to absorb the liquid fully, especially if it is a new wick.
Assemble the battery to the clearomizer. Simply twist clearomizer onto the battery
If your eGo-C Twist is not already on, press the button 5 times, button will flash when ready. To turn off, repeat step.
Vape\draw by Inhaling via the tank/clearomizer while pressing the button on the battery. Release the button just before you finish your draw so you are not vaping liquid and your draw "empties" your tank of vapor. By doing so, you have finished the first step. Enjoy!
Light will flash on and off on the eGo-C Twist when a charge is needed. You will also note that you cannot achieve a full, or any, draw from the tank.
Remove your tank from the unit by holding the bottom of the tank close to the battery, and twist the tank off of the battery. Take the USB charging cable & connect to battery. (Do not over tighten.)
Either Plug the USB into wall adapter and then plug adapter into wall, or plug the USB into a port on your computer or other device that can feed power to the charger. Battery light will flash 3 or 4 times when charge starts. Red lights will indicated when charging on USB, as well as on the wall adaptor if you are using that as well.
Allow a few hours for charge, the light on the USP will turn green when charge is complete.